Good Tip JayHawk
Yeah, I found a bunch of videos - works on all 2015 Jeeps and such except ours - classic. I couldn't get this to work.
It says not to start the engine in most, but then in step 3 it says withing 60 seconds of starting - I've read others that say 3 times within 10 seconds. Who knows - I will figure this out
This is the one I keep coming across
can be enabled or disabled by your authorized
dealer or by following these steps:
NOTE: The following steps must occur within the first
60 seconds of the ignition switch being turned to the ON
or START position. Chrysler Group LLC does not recommend
1. Turn the ignition switch to the OFF position, and
buckle the driver’s seat belt.
2. Turn the ignition key to the ACC/ON position (do not
start the engine), and wait for the Seat Belt Reminder
Light to turn off.
3. Within 60 seconds of starting the vehicle, unbuckle
and then re-buckle the driver’s seat belt at least three
times within 10 seconds, ending with the seat belt
4. Turn the ignition key to the OFF position. A single
chime will sound to signify that you have successfully
completed the programming.
BeltAlert can be reactivated by repeating this procedure.
NOTE: Although BeltAlert has been deactivated, the
Seat Belt Reminder Light will continue to illuminate
while the driver’s seat belt remains unfastened.
This is from a 2015 Cherokee
How do we get to the run mode? I couldn't figure that out. 90% sure we can't