Jeep Renegade Forum - View Single Post - Plan to install Kenwood KSC-SW11 Compact Powered Sub
View Single Post
post #5 of (permalink) Old 08-18-2018, 03:49 PM
Junior Member
DarthLifter's Avatar
Join Date: Jan 2018
Posts: 14
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 7 Post(s)
Ok. So I did some research on the KSC-SW11. I hate messing with the car fuse box. If it were me, I would just run the 12V+ and Ground all the way to the battery. Then I would tap the into the 4 rear wires behind the head unit and install an LOC w/remote turn on. Or take the route that is schemed up in the manual...roll the dice with tapping the fuse box for 12V+ and Ground and also the Accessory wire. In this case, an LOC is not needed as you would find the Accessory location on the fuse box and tap into it for your remote turn on.

For actually tapping the non-premium speaker wires I highly recommend using 20AWG Posi-Taps and Posi-Locks. Sooooooo easy. No cutting or soldering. Per online resources, the speaker wires behind the head unit are as follows:
Left Rear+ : Orange or OR/WT
Left Rear- : OR/BK or OR/BL
Right Rear+: Green or GR/RD
Right Rear- : GR/BK

*If using a LOC, please remember to correctly tune it before blasting your awesome sound machine

KSC-SW11 Manual :
Head Unit Connections - 2016 Jeep Renegade, Non-Premium Audio :
Axxess MX-MLOC725, LOC w/remote :
Posi-Tap Connectors :

Last edited by DarthLifter; 08-18-2018 at 03:58 PM.
DarthLifter is offline  

Search Tags for this Page

jeep renegade forum

renegade forum
2015 jeep renegade forum
2015 renegade forum
2015 jeep renegade