Jeep Renegade Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
I'm back to personalizing the TH. I'm Plasi-Dipping the burnt orange bezels to pearlized blue (Sierra Blue exterior). All other bezels came off fairly easily, but I cannot figure the mechanism by which the cup holder bezel is held in place.
I did remove the cup holder itself (pull all sides into the middle) and found one star head screw and a double sided clip below. Working them in unison does not allow any upward give, though the sides of the tunnel cover flex out when prying upward between the rim light and bezel.

I hope I don't have to remove the entire tunnel cover to reach the bezel clips, but I sure don't want to dip-paint the cup holder bezel in place in the interior.

Anyone have any experience with this?

Steve
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top