[omgashleigh]

Has anyone found any light bar mounts that fit the Renegade yet? I have the Trailhawk and I've been looking into a roof light bar, but I can't find any mounts that will fit!
Did anyone put off-road lights onto their Renegades? How do they look?

 

[Lackadazikal]

Link = http://www.jeeprenegadeforum.com/fo...d-ons/18449-let-s-put-some-lights-sucker.html

 

[astrobdean]

I used my roof rack. If you don't want a rack, you could use a set of Yakima/Thule type towers and a cross bar for a mounting point and go from there. Detailed write up in the "Aftermarket Accessories" area that Lack linked to shows how I ran wire.

 

[twospirits]

Call me crazy, but I wouldn't mind seeing a Jeep Liberty Renegade Roof Light bar on the Renegade. But they are hard to find, expensive if one is found and most likely will mean drilling into the roof. But I can dream though. lol

TS

 

[BumbleJp]

Has anyone found any light bar mounts that fit the Renegade yet? I have the Trailhawk and I've been looking into a roof light bar, but I can't find any mounts that will fit!
Did anyone put off-road lights onto their Renegades? How do they look?

I purchased Daystar's 40in light bar. The Jeep dealer couldn't figure out how to run the wire bundle to the light and gave me back the light bar. A local shop that does a "lot" of jeep mods won't install roof mounted light bars because of leakage through the roof penetration that often happens and then shorts stuff inside the car cab. It was supposed to be a "no" drilling required installation... or so said Daystar in their web add on Quadratec. I am going back to the dealer, and get info on how to remove and re-install the roof rails. I plan to drill a hole under the roof rail, that should give me access to the drivers side A-Pillar, where i can mount the switch pod that i also bought from Daystar. From there, i will have the local mod shop run the cable harness into the engine compartment and finish the install.

 

[Johfra]

Here is a write up of one way to do it .............. http://toasterjeep.com/index.php?th...0-kc-led-light-bar-installation-write-up.624/ .........
Here is another way ................ http://toasterjeep.com/index.php?threads/new-radiance-light-bar.892/#post-7952 ............... look at pics and make sure to read last post.
No idea if either of these is the way daystar tells you to do it, just for more ideas.